 |
| (I have blanked out the rest of my callsign.) |
It was a fun little project and a chance to see how the printable decal material works. It's nice stuff!
BUILDING A 1:1 BALUN
4 years ago
Sunday, May 17, 2020
A Small Project
I have had an inexpensive kit-built code-practice oscillator for years, built into the hard-plastic box it was sold in. The plastic was pretty brittle and the little widget had gotten knocked around over the years. It needed a new case.
So I gave it one. That's just a tea tin, with some added spray paint, a perforated metal backing to the thin metal on the (former bottom) front panel, labelled with home-made decals on laser-printable water-slide decal material.
The slowest part was waiting for the paint and lacquer to dry.
It was a fun little project and a chance to see how the printable decal material works. It's nice stuff!
It was a fun little project and a chance to see how the printable decal material works. It's nice stuff!
Subscribe to:
Post Comments (Atom)
11 comments:
Very Nice!
Nice!
Clean holes, how did you punch 'em?
That's super cool and a lovely little tea tin.
That turned out really nice.
I will have to check out the paper you mentioned.
"kmcoed"?
Typo, or like 'disamorced' in "Single Combat" - a catchy word from a favorite story?
"Disamorced" is way earlier than the Dean Ing novel. He probably got it from H. Beam Piper's 1957 short story, "Omnilingual."
How did you cut the hole in this sheet metal so neatly? How did you attach the 'screen' behind the hole?
Small holes can be made with a tapered awl. Larger holes require careful reaming -- and the speaker hole was done with a screw-drive punch, similar to the Greenlee chassis punches. At that, the edge is a little bent, but careful pressure with a demurring tool minimized it. It is tricky stuff to work with.
The screen attachment is nothing special -- the painted screws on each side of the speaker opening hold it in place (under the nuts are also long solder lugs that I bent down to hold the speaker). So does the switch, LED and key jack, since the perforated metal is roughly the same size as the panel. But the screws were first, and from there I could mark and ream the three larger holes. The thicker metal gives the panel a nice, solid feel.
Chassis punches... never used them before. Thanks for the tip.
Demurring tool. Gotta remember that term, too...
The Mac autocorrect got me again! "Deburring tool!" Shaviv made the first ones of the kind I like, or at the first ones I ever saw like them -- big handle, small blade with a slight hook and free to pivot in the handle. Here's one example:https://www.homedepot.com/p/SHAVIV-Classic-B-Deburring-Set-4-Piece-29065/309470914?mtc=Shopping-B-F_D25T-G-D25T-25_1_HAND_TOOLS-Multi-NA-Feed-PLA-NA-NA-HandTools_PLA&cm_mmc=Shopping-B-F_D25T-G-D25T-25_1_HAND_TOOLS-Multi-NA-Feed-PLA-NA-NA-HandTools_PLA-71700000034127224-58700003933021546-92700049573927173&gclid=CjwKCAjwh472BRAGEiwAvHVfGs9Ya3r0v4fGP00E9tDMQpy1vXHyvqJU596Na1oPjyBtOX0kmu8rfBoCXWgQAvD_BwE&gclsrc=aw.ds
But I DO hesitate to use that tool! It's a great accidental Rx-ism
Post a Comment